Job Management Partner 1/Automatic Job Management System 3 for Enterprise Applications Description, User's Guide and Reference

[Contents][Glossary][Index][Back][Next]

2.1.2 For UNIX

JP1/AJS3 for EAP is designed for use with a TCP/IP network configuration. Confirm the machine environment at the installation site before installing JP1/AJS3 for EAP.

This section describes the procedures for uninstalling and installing UNIX-compliant JP1/AJS3 for EAP.

Organization of this subsection
(1) Installing
(2) Uninstalling

(1) Installing

To install JP1/AJS3 for EAP, follow the procedure below.

(a) Prepare for installer startup

  1. Log in as a superuser or issue the su command to switch from a user to a superuser.

  2. Make sure that JP1/AJS3 for EAP is not running.

  3. Insert the supplied JP1/AJS3 for EAP media into the drive.

(b) Start Hitachi PP Installer

Start Hitachi PP Installer using the following command:

For HP-UX
# /usr/sbin/mount -F cdfs -r device-filename /cdrom
# /cdrom/IPFHPUX/setup /cdrom

For Solaris
# /cdrom/SOLARIS/setup /cdrom/cdrom0
Note
If the OS is Solaris, you do not need to execute the mount command.

For AIX
# /usr/sbin/mount -F cdrfs -r device-filename /cdrom
# /cdrom/AIX/setup /cdrom

When Hitachi PP installer starts, the initial window of Hitachi PP Installer appears.

(c) Install

  1. In the initial window, enter I.
    A list of the software that can be installed appears.

  2. Move the cursor to JP1/AJS3 for Enterprise Applications and press the space bar to select it.

  3. Enter I to install JP1/AJS3 for EAP.

  4. Enter Y or y.
    When installation is completed, enter Q to return to the initial screen.

For details about directories created during installation, see A. Directory List.

When the installation ends normally, perform the setup procedures required to use JP1/AJS3 for EAP.

(2) Uninstalling

To uninstall JP1/AJS3 for EAP, follow the procedure below.

  1. Log in as a superuser or issue the su command to switch from a user to a superuser.

  2. Check that JP1/AJS3 for EAP is not running.

  3. Execute the following command to start Hitachi PP Installer.
    # /etc/hitachi_setup
    When you start Hitachi PP Installer, the Hitachi PP Installer initial window opens.

  4. In the initial window, enter D.
    A list of uninstallable software programs appears.

  5. Position the cursor on JP1/AJS3 for Enterprise Applications and press the space bar to select it.

  6. Enter D.
    The Installer uninstalls JP1/AJS3 for EAP.

  7. Enter Y or y.

Once uninstallation is complete, enter Q. The initial window reappears.

[Contents][Back][Next]

[Trademarks]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.