![[Contents]](FIGURE/CONTENT.GIF)
![[Glossary]](FIGURE/GLOSS.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
Job Management Partner 1/Automatic Job Management System 3 System Design (Work Tasks) Guide
The following provides precautions (items you should know in advance) for using the Interval Control job.
Example of jobnets that use the Interval Control job are as follows:
- Register a jobnet for execution, and execute the succeeding job 30 minutes later.
For details about how to register a jobnet for execution, see 4. Executing an Application in the manual Job Management Partner 1/Automatic Job Management System 3 Overview.
As the wait time for the Interval Control job, you can specify a value from 0 to 1,440 (in minutes).
- Cautionary note
- The wait time you specify in the Interval Control job is the wait time for the interval control process, not the time from the start to end of the job execution. Depending on such factors as the status of the network at the time, the wait time might not exactly match the time you specify.
Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.