Job Management Partner 1/Integrated Management - Manager Overview and System Design Guide

12.2.5 Upgrading from JP1/Base version 8

To use JP1/IM - Manager, you must install JP1/Base version 9 on the same host. Note the following points when you upgrade JP1/Base on a manager:

• If there are any command execution log files from version 7 or version 6, make sure that you execute the jcocmdconv command after you upgrade JP1/Base and before you begin running JP1/IM.
  This command migrates command execution logs from the previous version to version 9. (If this is not done, the command execution logs cannot be accessed.)
  If you are using JP1/IM in a cluster environment, execute the jcocmdconv command once only on the logical host from either the primary node or secondary node with the shared disk online.
  See the section describing the jcocmdconv command in the Job Management Partner 1/Base User's Guide.
  
• The start sequence definition file is not updated when you upgrade. The definitions related to JP1/IM - Manager and the Central Console will need to be changed manually to the definitions of JP1/IM - Manager version 9.

For other cautionary notes that apply when upgrading JP1/Base, see the notes on installation and uninstallation in the Job Management Partner 1/Base User's Guide.

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.