KAMN727-I (Linux(x86))
Recovery of the device aa....aa was detected. (details code: bb....bb, server: cc....cc)
The device aa....aa that failed when the SCSI command was executed has been recovered.
aa....aa: Name of the device specified in the server environment definition operand in which the error occurred
For details about the device name, see the following table:
Operand name |
Environment |
Device name |
---|---|---|
scsi_device |
Multipath software is HDLM. |
HDLM logical device name |
Virtual environment based on VMware ESXi |
Symbolic link name |
|
Virtualization environment based on KVM |
||
All other cases |
||
dmmp_device |
Multipath software is DMMP. |
DMMP logical device name (/dev/xxx) is output at the end of the DMMP logical device name. xxx is the path for which the failure occurred. |
bb....bb: Detail code
Detail code |
Meaning |
---|---|
STANDBY_CHECK |
The processing to check the path status of the shared disk, which is executed periodically by the standby server, detected that the device had been recovered. |
ONLINE_CHECK |
The processing to check for shared disk reservations, which is executed periodically while the active server is running, detected that the device had been recovered. |
ONLINE_CHECK(NO_KEY) |
The processing to check for shared disk reservations, which is executed periodically while the active server is running, detected that the device had been recovered, but the restored path is in a state that is unable to update the disk. |
cc....cc: Server alias name of the server that is using the shared disk of aa....aa.
- S:
-
Resumes processing.
- O:
-
Take one of the following actions, as indicated by the detail code:
Detail code
Corrective action
STANDBY_CHECK
For a multipath configuration, check the path status by executing an HDLM, a DMMP, or an HFC-PCM command. If it has not been restored to the online status (failback), use an HDLM, a DMMP, or an HFC-PCM command to restore the online status (failback).
No action is required if a multipath configuration is not used.
ONLINE_CHECK
ONLINE_CHECK(NO_KEY)
As indicated by the content of message KAMN725-W, which is output before this message, see the section on handling shared disk device failures in the manual HA Monitor Cluster Software (for Linux(R) (x86) systems), and take the corrective action described there.