KAMN771-E

A failure or an event occurred during processing indicated by cause code cc....cc in replication device aa....aa.

aa....aa: Name of the replication device (specified in the server environment definition operand) in which the processing failed or an event occurred

bb....bb: Server alias name of the server that is using the replication device aa....aa

cc....cc: Cause code

The following shows the meanings of cause codes.

Cause code	Meaning
1	An attempt to configure primary suppression failed. Alternatively, an error occurred in the replication path in a multi-standby configuration.
2	An attempt to configure primary suppression on the remote host failed.

S:

Performs the following processing for the cause code.

Cause code	Processing
1	Stops the standby server.
2	Makes disk I/O of the active server remain stopped.

O:

Contact a system administrator.

Action:

Take one of the following actions, as indicated by the cause code.

Cause code	Action
1	Because the replication path has a failure, recover the replication path. After recovery, restart the standby server. Investigate the cause of the processing failure based on the execution log (/opt/hitachi/HAmon/spool/rep/monrep_ctl_replication-device-name.log).
2	If reset is performed by the standby system after this message is output, no action is required. If reset is not performed by the standby system, take actions in the following order. Do not perform hot-standby switchover by, for example, manually stopping the standby system. Recover the monitoring path and replication path from failure. Resume disk I/O by using the drbdadm resume-io command.