KAMN727-I

The device aa....aa that failed when the SCSI command was executed has been recovered.

         aa....aa: Name of the device specified in the server environment definition operand in which the error occurred

         For details about the device name, see the following table:

                        Operand name

                        Environment

                        Device name

                        scsi_device

                        Multipath software is HDLM.

                        HDLM logical device name

                        Virtual environment based on VMware ESXi

                        Symbolic link name

                        All other cases

                        dmmp_device

                        Multipath software is DMMP.

                        DMMP logical device name

                        (/dev/xxx) is output at the end of the DMMP logical device name. xxx is the path for which the failure occurred.

         bb....bb: Detail code

                        Detail code

                        Meaning

                        STANDBY_CHECK

                        The processing to check the path status of the shared disk, which is executed periodically by the standby server, detected that the device had been recovered.

                        ONLINE_CHECK

                        The processing to check for shared disk reservations, which is executed periodically while the active server is running, detected that the device had been recovered.

                        ONLINE_CHECK(NO_KEY)

                        The processing to check for shared disk reservations, which is executed periodically while the active server is running, detected that the device had been recovered, but the restored path is in a state that is unable to update the disk.

         cc....cc: Server alias name of the server that is using the shared disk of aa....aa.

               S:

                  Resumes processing.

               O:

                  Take one of the following actions, as indicated by the detail code:

                                 Detail code

                                 Corrective action

                                 STANDBY_CHECK

                                 For a multipath configuration, check the path status by executing an HDLM, a DMMP, or an HFC-PCM command. If it has not been restored to the online status (failback), use an HDLM, a DMMP, or an HFC-PCM command to restore the online status (failback).

                                 No action is required if a multipath configuration is not used.

                                 ONLINE_CHECK

                                 ONLINE_CHECK(NO_KEY)

                                 As indicated by the content of message KAMN725-W, which is output before this message, see the
                                    section on handling shared disk device failures in the manual
                                    HA Monitor Cluster Software (for Linux(R) (x86) systems), and take the corrective action
                                    described there.

Operand name	Environment	Device name
`scsi_device`	Multipath software is HDLM.	HDLM logical device name
	Virtual environment based on VMware ESXi	Symbolic link name
	All other cases	Symbolic link name
`dmmp_device`	Multipath software is DMMP.	DMMP logical device name (/dev/xxx) is output at the end of the DMMP logical device name. xxx is the path for which the failure occurred.

Detail code	Meaning
`STANDBY_CHECK`	The processing to check the path status of the shared disk, which is executed periodically by the standby server, detected that the device had been recovered.
`ONLINE_CHECK`	The processing to check for shared disk reservations, which is executed periodically while the active server is running, detected that the device had been recovered.
`ONLINE_CHECK(NO_KEY)`	The processing to check for shared disk reservations, which is executed periodically while the active server is running, detected that the device had been recovered, but the restored path is in a state that is unable to update the disk.