KAMN717-E
Failed to JP1 event notification. Event-ID=aa....aa Message-ID=bb....bb Function-name=cc....cc Status=dd....dd
An attempt to report a JP1 event has failed. The JP1 event has not been reported.
aa....aa: ID of event that was attemping to post a notification
bb....bb: ID of the HA Monitor message corresponding to the event that was attempting to post a notification
cc....cc: Name of the function that generated the error
dd....dd: Status code
|
Status code |
Meaning |
|---|---|
|
NO_LIBRARY |
Library not found. |
|
CONNECT_ERROR |
Cannot connect to JP1/Base. |
|
MAXOPEN |
The number of open files has exceeded the limit. |
|
NO_MEMORY |
Insufficient memory |
- S:
-
Continues processing.
- O:
-
Contact a system administrator.
- Action:
-
Eliminate the failure, based on the avoidance strategies in the table below. If the status codes is not found in this table, collect information as necessary.
Status code
Corrective action
NO_LIBRARY
JP1/Base might not have been installed.
Install it, and then restart HA Monitor.
CONNECT_ERROR
JP1/Base might not have been started.
Start JP1/Base.
MAXOPEN
Carefully review the kernel parameters, and then restart HA Monitor.
NO_MEMORY
Carefully review whether sufficient memory has been allocated to the system.