KAMN617-E


      
         HA Monitor terminated abnormally because an unrecoverable error occurred within HA Monitor.

         aa....aa: Abort ID

         
                        Abort ID

                     
                        Meaning

                     
                        213

                     
                        Abort when an attempt to add a host management table failed (due to the address operand in the HA Monitor environment settings being duplicated in a remote system)

                     
                        250

                     
                        Abort when a server failure was detected or a device failed to disconnect (due to a server failure while using the pairdown function or when a shared resource failed to disconnect during a hot standby)

                     
                        260

                     
                        Abort when local system failure is detected or a reset completion is received (due to the address operand in the HA Monitor environment settings being duplicated in a remote system)

                     
               S:

               
                  Terminates processing.

               
               O:

               
                  Restart the host. It is possible that resources have been corrupted, particularly if a file system is being used; be sure to restart the file system if one is being used.

               
               Action:

               
                  Eliminate the cause of the error based on the abort ID that is output. If the abort ID output is not listed above, contact maintenance personnel.

Abort ID	Meaning
`213`	Abort when an attempt to add a host management table failed (due to the `address` operand in the HA Monitor environment settings being duplicated in a remote system)
`250`	Abort when a server failure was detected or a device failed to disconnect (due to a server failure while using the pairdown function or when a shared resource failed to disconnect during a hot standby)
`260`	Abort when local system failure is detected or a reset completion is received (due to the `address` operand in the HA Monitor environment settings being duplicated in a remote system)