KAMN414-E

The host address is the same as that of one of the following:

• HA Monitor indicated by the IP address

• HA Monitor that uses the failure management processor indicated by the IP address

• HA Monitor that uses the hot-standby feature indicated by the IP address

If there is duplication, the following phenomena occur and the database might be damaged by mounting of both hosts:

• When the error occurs in a host, an error also occurs in other unrelated hosts that have a hot standby configuration.

• When a host is restarted, an error also occurs in other unrelated hosts that have a hot standby configuration.

If the local system is running in a virtual environment based on VMware ESXi and the detail code is SVP/HRL, the host address indicates the machine address.

aa....aa: Host address

bb....bb: IP address

cc....cc: Detail code

Detail code	Meaning
HA MONITOR	The host address is the same as that of the HA Monitor indicated by the IP address.
SVP/HRL	The host address or the machine address is the same as that of one of the following: HA Monitor that uses the failure management processor indicated by the IP address HA Monitor that uses the hot-standby feature indicated by the IP address

S:

Continues processing.

O:

Stop the local system or the HA Monitor indicated by the detail code, and then take one of the following steps:

• Separate the networks so that no messages are exchanged between hot-standby configurations.

• Assign different reset paths (including failure management processors) and port numbers used for monitoring paths to each hot-standby configuration so that messages are not transferred between different hot-standby configurations.

• Change the host addresses of all HA Monitors that share the network to unique values that are also unique within each hot standby configuration.

If you take the second or third step above, restart the HA Monitors whose settings were changed.

Do not restart the OS until you restart the HA Monitors.