KAMN276-E

A hot standby was attempted due to the occurrence of one of the events described below, but hot standby was stopped because there was no standby server:

• A program error was detected when 0 was specified for the server environment definition servexec_retry operand.

• A program error was detected when retry was specified for the server environment definition switch_error operand.

• The program restart limit was reached when a value other than 0 was specified for the server environment definition servexec_retry operand.

aa....aa: Server alias name

S:

Depending on the environment settings and other circumstances, the active server either restarts or stops.

O:

If the active server is not currently performing operations, start the standby server, and perform a planned hot standby manually, if necessary.

If the active server has not started, restart it.

Action:

Determine the cause of the server error. If you are using the monitoring function of a monitor-mode server (by specifying the ptrlcmd_ex operand for servers), determine the cause of the server error by referring to the execution logs of the monitoring commands that were recorded in the /opt/hitachi/HAmon/spool/ptrlcmd_ex/server-alias-name_ptrlcmdlog file.

If this error message is output and an error is detected immediately after starting the server, the settings might be incorrect. Verify that the settings are specified as follows:

• The newline code of the shell that is used from HA Monitor conforms to the OS.

• The syntax, path, and other settings related to the shell that is used from HA Monitor are correctly specified.