KAMN238-D
Standby server:aa....aa is starting wait state.
The active server has not started, so the standby server indicated by the server alias name becomes the active server in a startup wait-state.
This message is output at set intervals to report status to the user.
aa....aa: Server alias name
- S:
-
Continues processing.
- O:
-
Perform either of the following operations:
-
Start the active server.
-
Thoroughly verify that no active servers are running on remote systems#, and then execute the wait-state server startup command (monact).
#: If you execute the wait-state server startup command (monact) without sufficient verification and an active server was running on a remote system, two active servers will be running, which might result in the corruption of shared resources.
-