KFAA50043-E
An HADB server could not be returned to a multi-node configuration because aa....aa. (M)
The node cannot be returned to the multi-node configuration.
- aa....aa:
-
Cause of the error
- bb....bb:
-
Specified value of the operand in the server definition before change
- cc....cc:
-
Specified value of the operand in the server definition after change
- S:
-
Terminates processing.
- Action:
-
Take corrective action for the cause of the error displayed for aa....aa.
Display for aa....aa
Cause of the error
Corrective action to take
one of the HADB servers that composes the multi-node configuration is performing termination processing
One of the HADB servers in the multi-node configuration is performing termination processing.
Wait for completion of termination processing of the HADB server, and then perform the operation to return the node.
the master node is performing switchover processing
Master node switchover processing is in progress.
Wait for completion of master node switchover processing, and then perform the operation to return the node.
another HADB server is being returned to the multi-node configuration
Another node is being returned to the multi-node configuration.
Wait for completion of processing to return to the multi-node configuration, and then perform the operation to return the node.
an application or a command is connected to the HADB server
An application program or command is being connected to the HADB server in the multi-node configuration.
Wait for the application program and command to be disconnected, and then perform the operation to return the node.
a value specified in the server definition adb_sys_rthd_num the last time the HADB server was started was bb....bb. The value is now cc....cc
The value specified for the adb_sys_rthd_num operand in the server definition is changed.
Return the value of the server definition's adb_sys_rthd_num operand to its original value, and then perform the operation to return the node.