KFAA40204-E

An error occurred in I/O involving a file.

aa....aa: Processing that generated the error

• open: An error occurred when opening a file.

• read: An error occurred when reading a file.

• write: An error occurred when writing to a file.

• close: An error occurred when closing a file.

• reopen: An error occurred when re-opening a file.

bb....bb:

Name of file or directory where the error occurred

S:

Terminates processing.

Action:

Check the messages that were output before and after this message in the message log file, and eliminate the cause of the error. Then, re-execute the command.

If necessary, restore the database, and then re-execute the command. For details about how to restore the database, see the corrective action to take when a command terminates abnormally in the manual HADB Command Reference.

For details about what action to take for each error cause, see Troubleshooting in the HADB Setup and Operation Guide. If this message is output during command execution, also see Command-related problems in the HADB Setup and Operation Guide.

When no message indicating the cause of the error is output to the message log file, the following factors relating to file bb....bb are possible explanations:

• Permissions required for accessing file bb....bb might not have been set up.

• The disk area for storing the bb....bb file might be full.

• An I/O error might have occurred.

• The size of the input data file was changed while data was being imported.