Nonstop Database, HiRDB Version 9 Disaster Recovery System Configuration and Operation Guide
![[Contents]](FIGURE/CONTENT.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
Care must be exercised when the system definition operands are specified as follows:
- pd_rise_use=Y
- pd_rise_pairvolume_combination=hybrid
- pd_rise_fence_level=data
- pd_rise_disaster_mode = normal (or this operand is omitted).
- pd_log_remain_space_check=safe
- Note
- If the KFPS02178-E message is output after scheduling of new transactions has been suppressed with output of the KFPS01160-E message, synchronization points are no longer acquired, meaning that the percentage of free area for the system log files will always be below the warning value. In this case, perform the following procedure to correct the problem:
- Procedure
- Determine the why the KFPS02178-E message was output and take the appropriate corrective action.
- Execute the pdlogsync command on all servers whose status is TRNPAUSE, collect synchronization point dumps, and increase the percentage of free area for the system log files to at least the warning value.
All Rights Reserved. Copyright (C) 2011, Hitachi, Ltd.