The following table shows the operands you must specify when using Real Time SAN Replication.

Table 2-3 Operands that you must specify

Operand name	Real Time SAN Replication processing method
	All synchronous method	All asynchronous method	Hybrid method
pd_rise_use	Y	Y	Y
pd_rise_pairvolume_combination	sync	async	hybrid
pd_rise_fence_level	data or never#	Omitted	data or never#
pd_rise_disaster_mode	Omitted	Omitted	normal
HORCMINST	RAID Manager's instance number

#: Specifies the protection mode to be used.

The table below shows the operands that are subject to restrictions when Real Time SAN Replication is used. If you do not observe these restrictions, the KFPS01896-E error message is output when the pdconfchk command is executed or HiRDB is started.

Table 2-4 System definition operands subject to restrictions

Operand name	Restriction
pd_mode_conf	Specify MANUAL1 or MANUAL2.
pd_dbsync_point	When using the hybrid method, specify sync or omit this operand. When using the all synchronous or all asynchronous method, there are no restrictions.
pd_hostname	Cannot be omitted. Specify the standard host name of the main site or the remote site.