The pdtrnqing command can be used in the following execution environments:

• When a front-end server unit is used in a HiRDB single server configuration or HiRDB parallel server configuration.
• When the standby-less system switchover (effects distributed) facility is used.

This section describes the pdtrnqing command separately for each execution environment because the specification of the command depends on the execution environment.

Organization of this section

2.121.1 When executing the pdtrnqing command in a HiRDB single server configuration or on a front-end server unit

2.121.2 When executing the pdtrnqing command while using the standby-less system switchover (effects distributed) facility