Executor: Operation command executor or HiRDB administrator

The following table lists the possible causes of operation command execution errors.

Table 20-8 Possible causes of operation command execution errors and actions to be taken

Possible cause	Action to be taken
An invalid option or argument was specified in the operation command.	Correct the option or argument and re-execute the operation command.
The user does not have the required privilege to execute the operation command.	Refer to the HiRDB Version 9 Command Reference For details on user execution privileges for operation commands. If the user does not have the required execution privilege, either ask an authorized user to execute the command or obtain the required execution privilege.
A command available only while HiRDB is active was executed while HiRDB was inactive.	Check the HiRDB Version 9 Command Reference for whether the command can be executed while HiRDB is inactive. If the command is available only while HiRDB is active, start HiRDB and execute the command.
An operation command execution environment has not been set up.	Check that the following environment setup is correct: Environment variables Remote shell execution environment For details on these environment setup procedures, see the HiRDB Version 9 Installation and Design Guide.
A HiRDB system definition is invalid.	See the manual HiRDB Version 9 System Definition and correct the HiRDB system definition.