The following table shows the information that is inherited during a HiRDB restart.

Table 20-4 Information inherited during a HiRDB restart

Classification		Information that is inherited
System files	System log files	System recovery information
	Synchronization point dump files	Table recovery information
	Status files	Information used to determine the system startup mode: Server configuration Status information about each system server: Open/close status Primary/standby (alternate) status File shutdown status Service group shutdown status RDAREA-related information
User data (database)	RDAREAs	Open/close status Replica status of replica RDAREA Shutdown status#
Operation commands (status changes made by the commands shown at the right are inherited)	Database manipulation commands	pdclose (close RDAREA) pdopen (open RDAREA) pddbchg (switch replica status of replica RDAREA) pdorbegin (commit database reorganized online) pdorchg (switch current RDAREA reorganized online) pdorend (reflect online reorganization) pdhold (shut down RDAREA)# pdrels (release RDAREA from shutdown status)
	Commands for manipulating system log files or synchronization point dump files	pdlogadpf (allocate file) pdlogchg (change file status) pdlogcls (close file) pdlogopen (open file) pdlogswap (swap files) pdlogunld (unload file)
	Commands for manipulating status files	pdstscls (close file) pdstsopen (open file) pdstsswap (swap files)
	Commands for output of audit trails	pdaudbegin command (begin collection of audit trail) pdaudend command (end collection of audit trail)

Note

The following information is not inherited (these commands must be entered again after HiRDB is restarted):

• pdstbegin (start collection of statistical information)
• pdstend (terminate collection of statistical information)

#: The following hold statuses are not inherited:

• Referencing-permitted backup-hold (update WAIT mode)
• Updatable backup-hold
• Updatable backup-hold (WAIT mode)