Operands related to HiRDB Datareplicator

66) pd_rpl_hdepath = extracted-side-HiRDB-Datareplicator-directory-name

Specifies the extracted side HiRDB Datareplicator directory when the HiRDB Datareplicator linkage facility is used. Specify the name specified in the HDEPATH environment variable of the extracted side HiRDB Datareplicator.

Condition: This specification value is valid when the HiRDB Datareplicator linkage facility is being used and either Y is specified for the pd_rpl_init_start operand or the pdrplstart command is entered.

Note

To change the extracted side HiRDB Datareplicator directory name, it is necessary to change the HDEPATH environment variable of the extracted side HiRDB Datareplicator.
When Real Time SAN Replication based on the log-only synchronous method is used, the HiRDB Datareplicator linkage facility cannot be used at the log application site. This operand is ignored, if specified.

Relationship to other operands: If you specify the pd_rpl_reflect_mode operand, make sure that you also specify this operand.

3.2.21 Operands related to HiRDB Datareplicator