Executor: HiRDB administrator

Create HiRDB system definitions according to the designed system configuration and operating environment. This section discusses the following topics:

• Creating HiRDB system definitions
• Sharing HiRDB system definition files (HiRDB parallel server configuration only)
• Modifying HiRDB system definitions
• Modifying UAP environment definitions

For details about the HiRDB system definition operands, see the manual HiRDB Version 9 System Definition.

Notes

• After creating HiRDB system definitions, use the pdconfchk command to check their conformity. This command checks the definitions required for starting HiRDB for any inconsistencies. For details about the operands supported by the pdconfchk command, see the manual HiRDB Version 9 System Definition.
• Set and maintain permission to access the HiRDB system definition file so that only the owner of the file (HiRDB administrator) is granted read and write privileges.
• After modifying the HiRDB system definitions, be sure to back up the files under $PDDIR/conf. To protect against possible errors on the disk that contains the HiRDB directory, you need to back up the files in the HiRDB directory (files under $PDDIR/conf). To restore the HiRDB directory, you need a backup copy of the files under $PDDIR/conf.

Organization of this section

4.2.1 Creating HiRDB system definitions (HiRDB single server configuration)

4.2.2 Creating HiRDB system definitions (HiRDB parallel server configuration)

4.2.3 Sharing HiRDB system definition files (HiRDB parallel server configuration)

4.2.4 Modifying HiRDB system definitions (excluding UAP environment definitions)

4.2.5 Modifying a UAP environment definition