Executor: Superuser

Use Hitachi Program Product Installer to install HiRDB on each server machine.

Upgrading HiRDB

Before installing HiRDB, check for any active HiRDB under the installation directory (such as by using the OS's ps command). If there in an active HiRDB, after it is terminated normally using the pdstop command, execute the pdsetup -d command, respond with y to message KFPS00036-Q, and then delete HiRDB from the OS. After this, perform the installation.

HiRDB parallel server configuration

Install the same version of HiRDB on all server machines that constitute the HiRDB parallel server configuration.

Multi-HiRDB

When you install multiple HiRDB single server configurations or multiple HiRDB parallel server configurations, they all have the same installation directory. If you install multiple HiRDBs one after another, only the last HiRDB installed is effective because they all share the same installation directory.

Therefore, once you have installed the first HiRDB, create its HiRDB directory and register the HiRDB in the operating system (by following the procedures described in 2.3.1 Creating the HiRDB directory and 2.3.3 Registering HiRDB and option program products in the operating system). You can then install the next HiRDB.