This subsection describes the procedure for replacing an existing version of HiRDB with a more recent version.

Figure 1-2 Procedure for replacing an existing version with the new version

#1

• If you specify pd_auto_vrup=N in the system common definition, the pdvrup command does not start automatically. In this case, if the KFPS05203-Q message (pdvrup command entry request message) is issued, the HiRDB administrator must enter the pdvrup command.
• When you are updating to the HiRDB update version, the pdvrup command does not start automatically. Proceed to the next step.

#2

For the execution result of the pdvrup command, check the KFPX24404-I message in the message log file or syslog file.