Scalable Database Server, HiRDB Version 8 System Definition
![[Contents]](FIGURE/CONTENT.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
- 163) pd_auto_vrup = Y | N
- Specifies whether or not the pdvrup command for executing HiRDB version upgrading is to be started automatically. For details about how to upgrade the HiRDB version, see the HiRDB Version 8 Installation and Design Guide.
- Y: Start the command automatically.
- N: Do not start the command automatically (the HiRDB administrator must enter the pdvrup command).
- Specification guidelines
- Specify Y to upgrade a large number of HiRDB systems by using JP1/Software Distribution to distribute programs. This will eliminate the need to enter the pdvrup command at each HiRDB system.
- 164) pd_sysdef_default_option = recommendable | v6compatible | v7compatible
- Specifies use of a previous version's default values. This operand's default value depends on the version.
- recommendable: Applies the default values of the most recent version.
- v6compatible: Applies the default values of HiRDB Version 6 or earlier.
- v7compatible: Applies the default values of HiRDB Version 7.
- Specification guidelines
- Normally, omit this operand. This operand is used when problems arise from changing to the default values set by upgrading. For details about the applicable operands, see 1.4(1) Operands whose default value depends on the version.
All Rights Reserved. Copyright (C) 2007, Hitachi, Ltd.