JP1/Base

Events such as HiRDB startup and termination can be reported to JP1/Base (JP1/System Event Service in JP1 Version 6 and earlier). JP1/Base manages reported HiRDB events as JP1 events. This enables you to use JP1/Integrated Management to manage events and to automatically execute jobs by linking with JP1/Automatic Job Management System 2. For details about monitoring events with JP1/Integrated Management, see 2.5.6 JP1/Integrated Management. For details about executing jobs by linking with JP1/Automatic Job Management System 2, see 2.5.7 JP1/Automatic Job Management System 2.

For details about JP1/Base, see the manual that is applicable to the version of JP1 that you are using:

JP1 Version 8
Job Management Partner 1/Base User's Guide
JP1 Version 6 and JP1 Version 7i
JP1 V6 JP1/Base or Job Management Partner 1/Base
JP1 Version 5 or earlier
Job Management Partner 1/System Event Service

Organization of this subsection: (1) Reporting events

You specify the operands shown below to have HiRDB events reported to JP1/Base:

pd_jp1_use operand: Y
pd_jp1_event_level operand: 1 or 2

If you specify 1 for the pd_jp1_event_level operand, only basic attributes are reported. If you specify 2, extended attributes are also reported.

For details about the events that can be reported, see the HiRDB Version 8 Installation and Design Guide.

Note

In the following cases, 1 is the only value that can be specified for the pd_jp1_event_level operand (no events are reported if you specify 2):

Events are being reported to the JP1/System Event Service.
You are using the 64-bit mode HP-UX version of HiRDB.

2.5.5 JP1/Base

(1) Reporting events