OpenTP1 for Windows enables you to use a graphical user interface (GUI) to set up an environment for OpenTP1 and to start and terminate OpenTP1. Because these operations are independent of each other, you can, for example, use the GUI to set up an environment and then enter commands at the command prompt to start OpenTP1.
Check the following before you use the GUI provided by OpenTP1 for Windows:
- .NET Framework version
.NET Framework 2.0 or later must be installed in order to use the GUI. Install .NET Framework 2.0 or later, if necessary.
- User account control settings
If you use the GUI in Windows Vista or later, or Windows Server 2008 or later, the User Account Control dialog box is displayed before you start the GUI. Click the Allow button.
- Security policy settings
Specify full trust in the files listed below. The GUI cannot be used without the full trust setting. For details about how to specify the security policy settings, see the .NET Framework documentation.
- %DCDIR%\tp1_tools\Control.exe
- %DCDIR%\tp1_tools\Environment.exe
- Output destination of command logs and audit logs
Command logs and audit logs might be output when you use the GUI. However, these logs are not output to a multiOpenTP1 regardless of the target of the GUI operations.
- Organization of this section
- 6.7.1 GUI for environment setup
- 6.7.2 GUI for starting and terminating OpenTP1
All Rights Reserved. Copyright (C) 2012, Hitachi, Ltd.