If a system failure occurs in OpenTP1 and then OpenTP1 terminates during system restart processing that was initiated using either of the following methods, the OpenTP1 service status might remain as Stopping:

• Termination of OpenTP1 from the Windows Services dialog box
• Termination of OpenTP1 with a command

If such a failure occurs, first check the cause of the failure and take appropriate action. Then execute the dcstop command to terminate OpenTP1. For a multiOpenTP1, execute the dcstop command at the console that was created with the dcmakecon command. For details about the dcstop command, see List of operation commands in Chapter 7. Operation Commands. For details about the dcmakecon command, see dcmakecon (creates a multiOpenTP1 console) in Chapter 7. Operation Commands.