You can terminate OpenTP1 by entering one of the commands listed below from the command prompt. OpenTP1will terminate in the normal termination mode.
- net stop
Specify OpenTP1 in the argument (or OpenTP1_XXXX for a multiOpenTP1, where XXXX is a user-specified identifier). If the command cannot terminate OpenTP1 normally for some reason, OpenTP1 is terminated with a forced normal termination. If forced normal termination also fails, OpenTP1 is terminated forcibly. Note that once OpenTP1 has been terminated forcibly, it must be restarted (rerun) to start OpenTP1 operation.
- dcstop
For a multiOpenTP1, execute this command from the command prompt at the console that was created by dcmakecon XXXX (where XXXX is a user-specified identifier).
For details about the dcstop command, see List of operation commands in Chapter 7. Operation Commands. For details about the dcmakecon command, see dcmakecon (creates a multiOpenTP1 console) in Chapter 7. Operation Commands. For details about the net stop command, see the Windows documentation.
All Rights Reserved. Copyright (C) 2012, Hitachi, Ltd.