OpenTP1 Version 7 User's Guide

[Contents][Index][Back][Next]

6.2.2 Starting OpenTP1 with a command

You can start OpenTP1 by entering one of the following commands from the command prompt:

In OpenTP1 for Windows, OpenTP1 cannot be started with the dcstart command.

To start OpenTP1 in the forced normal startup mode from the command prompt, execute the ntbstart -n command. For a multiOpenTP1, you must execute this command from the command prompt at the console that was created by dcmakecon XXXX (where XXXX is a user-specified identifier).

For details about the ntbstart command, see ntbstart (starts OpenTP1) in Chapter 7. Operation Commands. For details about the dcmakecon command, see dcmakecon (creates a multiOpenTP1 console) in Chapter 7. Operation Commands. For details about the net start command, see the Windows documentation.