Reads a DAM data file and creates an offline tester DAM file.

• block-length ~((sector length x n - 8))
  Specify the block length of a DAM file.
  
• block-count ~((1-2147483647))
  Specify the number of blocks in a DAM file to be created. The DAM file size will be (block length x block count + 96) bytes.
  
• DAM-file-name ~<pathname>
  Specify the name of a DAM file to be created.
  
• input-file-name ~<pathname>
  Specify the name of a file that stores data to be output to the DAM file. Omitting this specification outputs null data to the DAM file.
  

• When an error occurs during utfdamcre command execution, the DAM file remains allocated. Before reexecuting the utfdamcre command, use the rm command to delete the DAM file.
• The following operations take place when the block count specified for the utfdamcre command differs from the block count in the input file.
  

  Specified block count > block count in the input file

  The system outputs blocks of null data to the end of the DAM file.
  

  Specified block count < block count in the input file

  The system stops reading blocks from the input file, issues message KFCA20789-W, then terminates the utfdamcre command.