This section explains the commands of the MCF online tester for running a test on a service group. For the format and rules of the operating commands, see the manual OpenTP1 Operation.

Table 9-6 lists the operating commands used for running tests on a service group.

Table 9-6 Operating commands for running tests on an application

Command name	Function
mcftulssg	Display of test mode information for a service group
mcftusgs	Start of a service group test
mcftusge	Termination of a service group test

Organization of this section

9.4.1 mcftulssg (display of test mode information for a service group)

9.4.2 mcftusgs (start of a service group test)

9.4.3 mcftusge (termination of a service group test)