To use the MCF simulator, activate the test MHP as a simulate MHP. Specify simmhp in the test_mode operand of the user service definition to create the simulate MHP.

To activate the simulate MHP, execute the OpenTP1 dcsvstart command or specify dcsvstart in the user service configuration definition.

To send a service request to the MHP, enter the utomhpsvc command. If a service request is sent in any other way, the online tester outputs an error message and skips execution of the requested service. In this case, the dc_rpc_call function terminates normally because the online tester accepts the service request, but response data for the service is not guaranteed.

The simulate MHP is activated as an SPP. This means that SPP commands must be used to run the simulate MHP. However, the utosppsvc command cannot be used.

To terminate the simulate MHP, execute the OpenTP1 dcsvstop command or dcstop command.