mmm it failed in the acquisition of the blank receiving buffer. connection name=aa....aa logical terminal name=bb....bb client internet protocol address=cc....cc receiving buffer group number=n maintenance code=(ddd,ee,ff,gg....gg,hh....hh)
- mmm: MCF identifier
- aa....aa: Connection name
- An asterisk (*) is displayed if the connection name cannot be determined.
- bb....bb: Logical terminal name
- An asterisk (*) is displayed if the logical terminal name cannot be determined.
- cc....cc: IP address of the connection destination terminal
- An asterisk (*) is displayed if the IP address cannot be determined.
- n: Receive buffer group number
- ddd: Matrix type
- ee: Matrix status code (maintenance information)
- ff: Matrix event code (maintenance information)
- gg....gg: Maintenance information 1
- hh....hh: Maintenance information 2
- S: Releases the connection.
- O: Re-establish the connection. If the same message does not appear again, the error was likely caused by a temporary receive buffer shortage, and you may continue operation. If this error occurs frequently, release the relevant connection or stop OpenTP1, and then contact the OpenTP1 administrator.
- Countermeasure: There are not enough receive buffers. Increase the number of buffers in the relevant group in the MCF configuration definition.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.