(aa....aa:bb....bb) If "N" is specified for clt_trn_conf, and no value or "N" is specified for clt_cup_conf, the operands specified in the client service definition other than clt_port do not take effect.
- For details about the message types and problem identification codes, see the explanation of the definition check command in the manual OpenTP1 System Definition.
- aa....aa: Message type
- bb....bb: Problem identification code
- S: Does not perform the logic check for the operands specified in the client service definition file, except for the clt_port operand. The system continues the logic check for the other files.
- Countermeasure: To use the client service, specify Y in the clt_trn_conf or clt_cup_conf operand. If you do not want to use the client service, ignore this message.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.