mmm error is detected during the processing to edit the send message. connection name=aa...aa logical terminal=(bb...bb,ccc,dd...dd) application name=ee...ee maintenance code=(f,gg,hhhhhhhh,iiii)

mmm: MCF identifier

aa...aa: Connection name

bb...bb: Logical terminal name

ccc: Logical terminal type

any: Any type

dd...dd: Operation mode

extend: Extended mode

noedit: Non-editing mode

ee...ee: Application name

f: Error identification

D: Invalid data

P: Invalid parameter specification

gg: Invalid data identification

00: Parameter

68: Extended host access message

ff: INC code

hhhhhhhh: Invalid data detail code

Bit position	ff (Invalid data type)
	ff	68	00
0	0	1: Invalid UAP name length 0: Normal	1: Invalid map name 0: Normal
1	0	1: Invalid user data length 0: Normal	1: Invalid segment type 0: Normal
2	0	0	1: Termination of continuous inquiry-response is not specified.# 0: Normal
3-31	0	0	0

#

When a continuous-inquiry-response type UAP started without inquiry-response from the host for exchanging extended host access messages, the UAP did not terminate continuous inquiry-response.

iiii: Message analysis relative position (maintenance information)

S: Outputs the KFCA16750-I message when the error identification is D.

Aborts the send message and performs either of the following according to the operation mode.

extend: Sends NOTIFY to the host.

noedit: Shuts down the logicalterminataing terminal.

O: Contact the OpenTP1 administrator.

Countermeasure: Check and correct the UAP, and retry.