mmm parameter set by UOC is invalid. connection name=aa...aa, logical terminal name=bb...bb, UOC type=cccc, error code=dd...dd
- mmm: MCF identifier
- aa...aa: Connection name
- bb...bb: Logical terminal name
- cccc: Type of user exit routine
- asct: User exit routine for line recovery confirmation
- mout: Output message editing user exit routine
- mrep: User exit routine for replying
- mrou: Alternate routing determination user exit routine
- dd...dd: Error code (maintenance information)
- 00000004: The range of timer values set by the user exit routine for editing output messages is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000005: The timer indicator set by the user exit routine for editing output messages is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000006: The alternate routing indicator set by the user exit routine that determines alternate routing is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000010: The return code from the user exit routine for replying is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000011: The length of the reply message is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000012: The number of buffers used for editing the reply message is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000013: The address of the editing buffer used for editing the reply message is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000014: The address of the editing buffer list is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000020: The return code from the user exit routine is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000021: The message length is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000022: The number of buffers used for editing the message is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000023: The address of the editing buffer is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000024: The address of the editing buffer list is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000025: The type of the received message is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000026: The timer value for receiving the test report message is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- 00000027: The retry count for sending the test command message is invalid.
- Check the user exit routine, correct the error, and then rebuild the MCF communication server.
- S: Releases the connection if the user exit routine type indicates the output message editing user exit routine.
- O: Contact the OpenTP1 administrator.
- Countermeasure: Remove the cause of the error indicated by the error code.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.