mmm error occurred when the system message was output. reason code=aa...aa, maintenance code1=bb...bb, maintenance code2=cc...cc, connection name=dd...dd, logical terminal name=ee...ee
- mmm: MCF identifier
- aa...aa: Reason code
- 00000001: An error occurred during buffer release processing.
- 00000002: An error occurred during mapping.
- 00000003: An error occurred during sending.
- 00000004: An error occurred while checking the send buffer length.
- 00000005: An error occurred while allocating the process-specific area.
- 00000006: There are too few buffers.
- bb...bb: Maintenance code 1
- cc...cc: Maintenance code 2
- dd...dd: Connection name
- ee...ee: Logical terminal name
- S:
- For 00000001 or 00000004
- Ignores this error and continues processing.
- For 00000002, 00000003, 00000005, or 00000006
- Proceed as indicated in the message issued immediately before this message.
- O: Contact the OpenTP1 administrator.
- Countermeasure: Take whichever of the following actions is appropriate for the displayed reason code:
- 00000001: Contact the maintenance personnel.
- 00000002: Proceed as indicated in the message issued immediately before this message.
- 00000003: Proceed as indicated in the message issued immediately before this message.
- 00000004: Check the send buffer length, then re-execute.
- 00000005: Proceed as indicated in the message issued immediately before this message.
- 00000006: Proceed as indicated in the message issued immediately before this message.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.