mmm maintenance information=(a,bbb,cc,dd,eeeeeeee,ffffffff)

mmm: MCF identifier

a: Error type

S: Sequence error

M: Matrix exception

R: XNF macro error

bbb: Matrix identification

atm: Session management matrix

snd: Send type matrix

rcv: Receive type matrix

slu: HNA2 interface processing matrix

cc: Matrix status code (maintenance information)

dd: Matrix event code (maintenance information)

eeeeeeee: Reason code 1

ffffffff: Reason code 2

Reason codes and their corresponding countermeasures are listed in the table below.

S: Proceed as indicated in the KFCA15051-E or KFCA15053-E message output immediately before this message.

O: Contact the OpenTP1 administrator.

Countermeasure: Referring to the reason code list, take appropriate action.

When reason code 1 is 3272000c:

Reason code 2	Meaning	Countermeasure
39000100	The specified host connection destination ID or local station LU number is invalid.	Check the value specified in the sluno or pluno operand of the -l option for the mcftalcsc command, specify a valid value, then re-execute.
3d000a00	Transmission is impossible because there are too many send data items.	Check whether the maximum SLU send RU size, specified at XNF/W setup or in the XNF/S-E2 configuration definition, is equal to or greater than (maximum length of the local system send message + 64 bytes), specify a valid value, then re-execute.
Other than above (gg00hhii) gg: Macro type 37: h2_open 38: h2_close 39: h2_bind 3a: h2_unbind 3b: h2_connect 3c: h2_listen 3d: h2_snd 49: h2_rcv 4a: h2_look hh: h2_errno# ii: errno#	XNF macro error	Obtain maintenance information, then contact the maintenance personnel.

#

For h2_errno and errno, refer to the error information and error code for the HNA secondary station (when using SLUS) in the manual XNF/S-E2 Description.

When reason code 1 is 32720013 or 32720014:

Reason code 2	Meaning	Countermeasure
b0000000	Once the session is established, a release request is received from the remote system.	Check the remote system status, then re-execute.
d0000000	Once the session is established, a release request is received from the remote system.

When reason code 1 is 32720015 or 32720016:

Reason code 2	Meaning	Countermeasure
b000jjjj jjjj: Sense data	Once the session is established, a negative response is received from the remote system.	Check the remote system status, then re-execute.

When reason code 1 is 32720018:

Reason code 2	Meaning	Countermeasure
Send RU length	When a message is sent, the maximum send RU length is exceeded.	Adjust the specified maximum receive message length of the remote system such that a message having the length indicated in reason code 2 (hex) can be sent, then re-execute.

When reason code 1 is any other code:

Reason code 2	Meaning	Countermeasure
Undefined	Protocol error detection	Obtain maintenance information, then contact the maintenance personnel.