OpenTP1 Version 7 Messages
KFCA14500-W
mmm communication error detected for connection. connection name=aa...aa reason code=bb...bb detail error information=cc...cc stop code=dd...dd error detail code=ee...ee line name=ff...ff
- A communication error was detected for the connection to the remote system.
- mmm: MCF identifier
- aa...aa: Connection name
- bb...bb: Reason code (Maintenance information)
- cc...cc: Detail error information (Detailed error information for the communication manager)
- dd...dd: Stop code (Stop code for the communication manager)
- ee...ee: Error detail code (Error detail code for the communication manager)
- ff...ff: line name
- S:
- HSC1 procedure:
- In the event of an HSC procedure error, recovers the connection.
- In all other cases, shuts down the connection.
- HSC2 procedure:
- If the mode is synchronous at the time of a send failure, the corresponding logical terminal is placed under implicit shutdown.
- If the mode is asynchronous at the time of a send fail, a retry takes place according to the mcftalccn specification in the MCF communication configuration definition.
- In the event of an HSC procedure error, disconnects the line (connected), and implicitly shuts down the logical terminal (rejects termination if an HSC error is detected during a termination request). However, the system does not shut down the logical terminal if a DLE.EOT send request has been accepted from the UAP before the UAP is notified of the detection of an HSC procedure error.
- In all other cases, shuts down the connected logical terminal.
- O: Contact the OpenTP1 administrator.
- Countermeasure:
- HSC1 procedure:
- Eliminate the error cause.
- HSC2 procedure:
- Eliminate the error cause. (For unsuccessful origination, retry origination after a sufficiently long period has elapsed.)
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.