mmm error occurred during output mapping. discards output message. reason code=aa...aa maintenance code1=bb...bb, maintenance code2=cc...cc, logical terminal name=dd...dd

mmm: MCF identifier

aa...aa: Reason code

00000001: Process-specific memory became insufficient.

00000002: The send buffer size became too small.

00000003: The number of send buffers became too small.

00000004: The map name length is invalid or the map name is not set.

00000005: An error occurred on the mapping service.

99999990: A logic conflict occurred.

bb...bb: Maintenance code 1

cc...cc: Maintenance code 2

dd...dd: Logical terminal name

S: Discards the output message and continues processing if it is a response message; retains the output message and continues processing if it is a branch message.

O: Contact the OpenTP1 administrator.

If the message containing the error is retained in the output queue, the message is output again when the operation is re-executed. If the retained branch message is not needed, execute the mcftdlqle command or use the dc_mcf_tdlqle function to discard the output message.

Countermeasure: Take one of the following countermeasures according to the reason code:

00000001: Allocate sufficient process-specific memory and re-execute.

00000002: In the connection definition of the MCF communication configuration definition, set the message receive buffer length to a value larger than the value indicated by maintenance code 2. Then, re-execute.

00000003: Specify the sufficient number of message receive buffers in the connection definition in the MCF communication configuration definition and re-execute.

00000004: Set a map name with 1 to 6 characters and re-execute.

00000005: The code indicated by maintenance code 2 is the error detail code of mapping service. See the manual OpenTP1 Protocol TP1/NET/XMAP3 and correct the source of the error.

99999990: Contact the maintenance personnel.