mmm error was detected while activating application. module ID=aa...aa, error code=bb...bb maintenance codes=(cc...cc, dd...dd, ee...ee)
- An error is detected while activating the application.
- mmm: MCF identifier
- aa...aa: Module ID
- bb...bb: Error code
- cc...cc: Maintenance code 1
- dd...dd: Maintenance code 2
- ee...ee: Maintenance code 3
- S: Continues processing.
- O: Contact the OpenTP1 administrator.
- Countermeasure: Eliminate the cause of the error according to the previous message and re-execute.
- If the error code is -10338, remove any of the causes listed below before executing the command again.
- The application start service has not been activated.
- The corresponding logical terminal is missing.
- There is something wrong with the OpenTP1 system definition; for example, the application start process identifier is not set in the -p option of the application environment definition.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.