mmm failure to get application name. connection name=aa...aa, logical terminal name=bb...bb, error code=cc...cc

mmm: MCF identifier

aa...aa: Connection name

bb...bb: Logical terminal name

cc...cc: Error code

-10207: Local memory is insufficient.

Allocate sufficient memory to enable operation of the MCF communication process.

-11528: The buffers for editing messages are insufficient.

Carefully review the number of buffers in the MCF communication configuration definition mcftbuf command.

-11548: The number of used buffers is invalid when control returns to OpenTP1 from the message input editing user exit routine.

Check and correct the user exit routine. Then re-create the MCF communication process.

-11576: The receive message segment begins with a space character (the application name is invalid).

Change the format of the application name sent from the remote system.

-11580: The valid segment length is invalid when control returns to OpenTP1 from the message input editing user exit routine.

Check and correct the user exit routine. Then re-create the MCF communication process.

-11581: The edit buffer list address is invalid when control returns to OpenTP1 from message input editing user exit routine.

Check and correct the user exit routine. Then re-create the MCF communication process.

-11582, -11592: The format of the application name is invalid when control returns to OpenTP1 from the message input editing user exit routine.

Check and correct the user exit routine. Then re-create the MCF communication process.

-11583, -11593: The application name length is invalid when control returns to OpenTP1 from the message input editing user exit routine.

Check and correct the user exit routine. Then re-create the MCF communication process.

-11584, -11594: The first nine bytes of the receive message segment do not contain a space character (the application name length is invalid).

Change the length of the application name sent from the remote system.

-11585, -11595: The application name length is invalid in the receive message segment (the length is 0).

Change the length of the application name sent from the remote system.

0 or -19000 to -19999: Detailed return information from user exit routines

Other error codes: Maintenance information

Take corrective action as indicated in the error message that was output before this message.

S: Continues processing.

O: Contact the OpenTP1 administrator.

Countermeasure: Take action according to the error code.