mmm MCF operation command terminated abnormally. command name=aa...aa error code=nn...nn

mmm: MCF identifier

aa...aa: Command name

nn...nn: Error code

The table shows the correspondence between the error codes and the countermeasures.

S: Terminates command processing.

O: Refer to the previous message and eliminate the cause of the error. Alternatively, contact the OpenTP1 administrator.

Error codes

Error code	Meaning	Countermeasure
-15201	OpenTP1 is being started.	Re-enter the command after OpenTP1 is started.
-15209	The inter-thread communication failed.	Contact maintenance personnel.
-15215	OpenTP1 is begin started.	Re-enter the command after OpenTP1 is started.
-15217	OpenTP1 is being terminated.
-15240	The specified connection destination name is being used.	Wait until the specified connection destination name becomes available and re-enter the command.
-15241	The specified connection destination list identifier is invalid.	Check the specified connection destination name and the connection destination definition list.
-15242	The specified connection destination name does not exist in the specified connection destination list.
-15243	An unrecoverable error or an unexpected error occurred.	Contact maintenance personnel.
-30300	An analysis error is found in the entered address information.	Refer to the previous message.
-30301	Memory is insufficient.	Check the amount of the memory available.
-30302	An unrecoverable error or an unexpected error occurred.	Contact maintenance personnel.
Other codes	Other errors	Contact the OpenTP1 administrator.