mmm failure to respond to MCF operation command process. command name=aa...aa reason=bb...bb processing function=cc...cc position=dd

mmm: MCF identifier

aa...aa: Command name

bb...bb: Reason code

Reason codes and countermeasures are listed in the table below.

cc...cc: Processing function name (maintenance information)

dd: Serial number in the processing function (maintenance information)

S: Terminates command processing.

O: Contact the OpenTP1 administrator.

Countermeasure: Refer to the reason code list, then take appropriate action.

Reason code	Meaning	Countermeasure	Output destination
-301	A specified argument is invalid.	Contact your Hitachi customer engineer.	Message log file
-302	A function issue order error occurred.
-303	An unrecoverable or unexpected error occurred.
-304	There is insufficient memory.	Check the amount of memory being used.
-306	A network error occurred.	Determine the cause of the error by applying the following procedure: Check the node connection status by using a command provided by the OS. Check the execution status and output message of the MCF operation command input origin.
-307	An exchange timeout occurred.
-308	The input parameter length exceeds the limit.
-314	There is no process provided by the relevant service.
-19178	A request for an operation command was received by one of the following processes, but the number of sendable RPC communications in the response communicating the processing result exceeded the maximum: MCF manager process	Take one of the following actions to reduce the number of service groups, services, applications, or logical terminals covered by a single operation command execution: Do not use batch specification when executing operation commands. Add prefix character strings when using batch specifications.	Standard error output
	MCF communication process Application start process	Example: In this example, batches are specified with prefix character strings using the following conditions: No. of applications: 4,000 Application names: APAnnnn, APBnnnn, APCnnnn, APDnnnn (nnnn: positive integer between 0001 and 1000) Example specifying batches with prefix character strings: mcftactsg -g "APA*" mcftactsg -g "APB*" mcftactsg -g "APC*" mcftactsg -g "APD*" Execute a show status command provided by the MCF (such as the mcftlssg command, which shows service group status) to determine whether the operation command request was processed normally. Carefully review whether the upper limits of status inheritance definitions for service groups, services, applications, or logical terminals (mcfmsts -g option, mcfmsts -v option, mcftsts -a option, or mcftsts -l option) have been exceeded. If this message is output when one of the following operation commands is executed, reduce the number of applications or logical terminals the operation command is executed on, and then re-execute the command. mcfaclcap mcfadltap mcftactmj mcftdctmj