mmm get to trace data is no start.

This message appears in either of the following situations:

1. When the mcftswptr command for forcible swapping MCF trace files is executed, but the acquisition of trace data has already terminated because the mcftstptr command for terminating the MCF trace acquisition was executed.
2. When an MCF communication service detected an error and attempted forcible swapping of MCF trace files, but forcible swapping had already been performed by another MCF communication service detecting an error.

mmm: MCF identifier

S: Does either of the following:

• When the cause of the message output is 1: Ignores the command and continues processing.
• When the cause of the message output is 2: Terminates the system abnormally without forcibly swapping MCF trace files.

O: If you want to execute the forcible swapping command (mcftswptr), use the mcftstrtr command to start the acquisition of the MCF trace, and then execute the command.