OpenTP1 Version 7 Messages
aaaa(bbbbbbbb) journal cannot be connected to the archiver(cccccccc@dddd). reason code=eeee
Reason code | Meaning | Operator action | OpenTP1 administrator action |
---|---|---|---|
113 | The archive service was abandoned because the relevant system terminated. | -- | -- |
427 | Both of the following conditions were satisfied:
|
Correct the value of the jnl_arc_max_datasize operand in the archive journal service definition for the archive node. After the correction, restart the archive source node and the archive node. | -- |
1301 | The archive service was abandoned because there is no archive resource group to be connected. | Modify the system journal service definition. Operate the journal in the relevant node until processing restarts normally. | Check that there is no error in jnl_arc_node of the system journal service definition and whether the system configuration is correct. |
2001 | The archive service was abandoned because the number of archives to be connected exceeded the maximum number of archives that can be connected. | ||
2002 | The archive service was abandoned because there is insufficient shared memory in the archiver to be connected. | Re-estimate the amount of shared memory needed by the archiver to be connected. | |
2003 | The archive service was abandoned because its version does not match that of the archiver to be connected. | Check which versions of the archiver can be connected, then check whether the version of the system to be connected is supported. If the version cannot be connected, change the system as far as is possible. | |
2004 | The associated run already suspended the archive service. | -- | |
2006 | A connection attempt was made at a specified time. However, connection failed and the archive service was abandoned. | Modify the system journal service definition. Operate the journal in the relevant node until processing restarts normally. | -- |
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.