no record found to be output.

There are no records that satisfy the conditions specified in the command input parameters.
This message is output upon the occurrence of any one of the following:

• The specified journal record type does not exist.
• The start record time in a file is later than the record end record time.
• The end record time in a file is earlier than the first record time.
• There is no record for the specified transaction ID.
• There is no record in the specified journal acquisition mode.

S: Aborts processing.

O: Check that no input error occurs in the input parameter output range (specified with the -t option).

If the input is correct, contact the OpenTP1 administrator.

Countermeasure: Check that all specified command parameters are valid.

When specifying the -e option (extract committed UJ) without the -l option (extract committed UJ from the final file), the output records may be sent to the inheritance file. In this case, be sure to specify the inheritance file at the next command execution.