OpenTP1 Version 7 Messages
KFCA01844-E (L+E)
error occurred while terminating server aa...aa.
reason code=bb...bb
- aa...aa: Server with an error
- bb...bb: Possible causes are:
- COMMUNICATE: Inter-process communication error
- EXIT: In halt state (no server), or now terminating
- ABORTING: Server now terminating abnormally (dcsvstop)
- CRITICAL: Forced termination suspended because of critical state
- MEMORY: Insufficient memory
- ABORT: Server terminated abnormally (dcstop).
- ABNORMAL: After trying termination with dcstop, the server was found to have not terminated normally.
- CANNOT END: Forced termination is impossible because of SUP.
- PROTOCOL: dc_adm_complete (for SUP) or dc_rpc_mainloop (for SPP) was not issued.
- CANCEL NORMAL: Normal termination of the user server with dcsvstop is impossible because Y is specified for the set cancel_terminate in the user service definition or user service default definition (normal termination of the system with dcstop is possible).
- S: Continues OpenTP1 processing.
- O: Remove the cause of the error and then terminate the server. Check if all servers terminated because some may not have terminated. They may accept only forced termination (dcsvstop -f or dcstop -f) according to the timing of previous termination.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.