select OpenTP1 start mode. [s: normal start, r: restart, t: terminate]

Normal start of OpenTP1 was instructed, but a message re-inquires which start mode to use because the previous OpenTP1 termination mode was not normal termination.

S: Outputs the message as the standard output and then reads one line from the standard input. If the line begins with s, the system starts OpenTP1 normally. With r, the system restarts OpenTP1. With t, the system terminates OpenTP1. With other than those characters, the system repeats output of the message and reading one line from the standard input.

O: Select one of the following:

s: Normal start

r: Restart

t: Terminate