An error occurred during aaaa(xx....xx) automatic unloading. (reason code = bbbb)

An error occurred during processing the automatic unload function.

aaaa: Type of journal file (Up to four alphanumeric characters)

sys: System journal file

xx....xx: Resource group name

bbbb: Reason code indicating the contents of the error (Up to four numerals)

101: Memory is insufficient.

103: A network failure occurred.

209: An I/O error occurred during access to the journal file created on the OpenTP1 file system.

503: An error occurred during I/O processing of the status file.

1602: Block omission was detected in the journal file. The journal file may have been corrupted.

1607: The file group is not used for online processing.

1612: An error occurred during access to the journal file.

S: Stops the automatic unload function.

O: Correct the error according to the reason code, and then execute the jnlatunl command to restart the automatic unload function.

101: Check memory usage.

103: After restoring the network, restart the system.

209: Investigate the cause of the I/O error, and take countermeasures. Alternatively, re-create the OpenTP1 file system on another disk device or in another partition.

If an attempt to read the journal file failed, the system only cancels unload processing and does not stop the automatic unload function. In this case, execute the jnlunlfg or jnlchgfg command to put the journal file in the unloaded state.

503: Investigate the cause of the error, correct the error, and then restart the system.

1602: Cancel unloading of the file group, and then contact the OpenTP1 system administrator and maintenance personnel.

1612: Take action according to the previous system call error message or the KFCA04191-E message.