cannot start aaaa (xx...xx) journal file service. reason code=bbbb

An error occurred during startup or restart processing for the journal file service.

aaaa: Type of journal file. (Up to four alphanumeric characters)

sys: System journal file

jar: Archive journal file

xx...xx: Resource group name

bbbb: Reason code indicating the cause of the error. (Up to four numerals)

The table below shows the reason codes and countermeasures.

S: Terminates OpenTP1.

Countermeasure: Take countermeasures according to the reason code. Then, restart OpenTP1.

Reason code	Meaning	Countermeasure
101	Insufficient memory	Check the amount of used memory.
103	Network failure	Recover the system from the failure and restart it.
114	The message queue ID table in the system does not have a free area.	Re-configure the kernel by changing the maximum allowable number of message queues specified in the system parameter. For details, see the relevant OS documentation.
116	An attempt was made to re-create the deleted message queue, but failed due to lack of free area in the message queue ID table in the system.	Use the current node for journal operation until the next normal start or restart. Reconfigure the kernel by changing the maximum allowable number of message queues specified in the system parameter. For details, see the relevant OS documentation.
405	An error is detected during definition analysis processing.	Check and correct the definition file. Then, restart the system. Message KFCA002XX shows details of the error.
414	The number of valid journal file group definitions is smaller than the minimum number of generations required for system startup.	Correct the system journal service definition or the jnladdfg definition for the archive journal service definition, and then restart the system.
416	The number of jnladdpf definition commands having the same file group name is smaller than the value specified in the jnl_min_file_dispersion operand.	Correct the system journal service definition or the jnladdpf definition for the archive journal service definition, and then restart the system.
418	The value specified in the jnl_min_file_dispersion operand is greater than the value specified in the jnl_max_file_dispersion operand in the system journal service definition or archive journal service definition.	Correct the values of the jnl_max_file_dispersion and jnl_min_file_dispersion operands in the system journal service definition or archive journal service definition.
420	The set jnl_arc_name operand is specified in the system journal service definition. TP1/Multi, however, is not installed.	Install TP1/Multi if it is not installed. If it is installed, check the multi_node_option operand is specified in the system common definition.
425	The value specified in the jnl_arc_max_datasize operand in the system journal service definition is incorrect.	Correct the value of the jnl_arc_max_datasize operand, and then restart the system.
426	A value greater than 1020 is specified in the jnl_arc_max_datasize operand in the system journal service definition or archive journal service definition, but a small value is specified in the rpc_max_message_size operand in the system common definition.	Correct the value of the jnl_arc_max_datasize operand or the rpc_max_message_size operand, and then restart the system.
427	The value specified in the jnl_arc_buff_size operand in the system journal service definition is invalid.	Correct the value of the jnl_arc_buff_size operand, and then restart the system.
503	An error occurred during I/O processing of the status file.	Investigate the cause of error, correct the error, and restart the system.
506	An error occurred while starting the journal I/O service process.
510	An error occurred during the journal file check processing.	Investigate the cause of error, correct the error, and restart the system. Details of the cause of the error are displayed before this message.
513	An error occurred while starting the service recovery journal service.